Airflow-Mod for Bigscreen Beyond 2 / 2e
Less heat. Clear lenses.
In a long sim race, a long flight or a late night in VRChat, the air around your eyes gets warm and humid. And that is when you do not want to take the headset off.
This mod keeps the area around your eyes cooler and stops lens fogging. It uses the headset's own fan to pull warm, humid air out of the eye area all the time.
No extra electronics / Made for 3D printing / Adjustable airflow
How it works
The headset's fan does the work
The body is an air channel with a chamber in the middle. The headset's fan pulls air out of this chamber through four outlets. This makes the pressure in the chamber lower than the pressure of the room air.
With the slider closed, air can only enter through six inlets at the two ends of the body. These inlets sit in openings that the headset already has. Channels inside the headset connect them to the eye area. So part of the warm air is pulled out of the eye area, and fresh air flows in to replace it.
Extra benefit
Much less lens fogging
Lenses fog when warm, humid air from your skin touches a lens that is colder than the dew point of this air. Below that temperature, the moisture turns into tiny drops on the lens.
The mod keeps pulling this humid air out. Drier room air enters at the lower outer edge of each lens opening, flows past the lens and leaves at the top, straight into the mod. Less moisture in front of the lenses means less fog. In practice, the lenses rarely fog, and if they do, they clear quickly.
Airflow control
The slider sets the strength
The slider does not change how much air the fan moves. It changes where the air comes from. Air can reach the chamber in two ways: through the long, narrow channels from the end inlets, or through two short openings in the cover. The slider opens and closes these two openings. They work as a bypass.
When you open the slider, room air takes the easier way through the cover. The suction at the end inlets gets weaker, so less air is pulled out of the eye area. With the slider fully open, about three quarters of the air comes in through the bypass.
Close it for the strongest effect. Open it for a gentle airflow.
Get the files
Two versions
Both work with the Custom-Fit Cushion and with the Universal-Fit Cushion.
Airflow-Mod v2$20
This is the version shown on this page. Compared to v1:
- AirflowMuch stronger. The inner channels were improved with airflow simulation (CFD).
- ControlThe slider adjusts the airflow much more precisely.
- FitSits more firmly on the headset.
- PrintingEasier to print.
What you get
- STLbody, adapter, cover
- Slidernine widths in 0.02 mm steps, so you can pick the best fit for your printer
- 3MFtwo print plates, ready to print
Airflow-Mod v1Free
The first design: body, cover and slider. Includes STL files and ready-to-print 3MF files.
Download v1 (ZIP)Free for personal, non-commercial use (CC BY-NC 4.0).
No 3D printer?
A printed version is planned. Enter your email address and you will get a message when it is available.
Your address is used only for this one message.
BSB2 Airflow-Mod is an independent project for the Bigscreen Beyond 2 and Beyond 2e. It is not affiliated with or endorsed by Bigscreen.
The headset in the 3D view is based on the Bigscreen Beyond 3D printable model by Bigscreen, used under CC BY 4.0. It was simplified for this page and shows the first Beyond.
Use at your own risk. You are responsible for any changes to your headset. The files come as they are, without warranty. The author accepts no liability for damage to the headset or other equipment.